Motion Detector on the Mobile Phone

Shocks that occurred in the phone has an effect that can be harmful to the components therein. Lucky mobile component has been protected with a mechanism so neat. Thus, a relatively small shocks can be muted so as not to cause a bad effect.

"Motion Detector on the mobile phone"
Mobile phones: the Nokia 3650


Materials and Equipment:
1. Toy ball with lights
2. Key chains that can be read
3. Electrical Solder
4. Tin solder
5. Scotch tape
6. Sharp knife / Cutter
7. Cutting pliers

The execution steps:
1. Toys that resemble ordinary rubber ball cut using a sharp knife / Cutter. Inside there is a marble-like spheres that contain electronic circuits. This marbles divisive spheres by using sharp knives and cutters in the center ring. We only require a motion sensor in it. Cut out the parts that are not needed to use the cutting pliers so the only remaining motion sensor.
2. This key chain ornament cleaved using a sharp knife / cutter. Electronic circuits contained therein was issued. Note the battery cable positive path and a negative path. Switch on the cable and then connected to motion sensors using electrical solder.
3. Disassemble the phone starts from the front. Unplug the machine so it looks like the mobile phone antenna.
4. Lift out the cellular antenna. Create a round pieces such as speakers by using the heat from soldering irons. This sphere will be fitted with the size of the speakers listed on the appliance.
5. Connect the appliance with the position of the speaker facing down. Close the rear speakers with thin masking tape to avoid short circuits / shorting. Insert a thin cable so as not to impede the engine when it is paired. Make way for the wires to where the machine (in addition to the bone phones).
6. The hardest part is putting a motion sensor device. Strive to be a motion sensor is not stuck. When you need to dispose of part of the bone phones using electrical solder. Test by attaching a battery. When sound came out when the sensor is pressed means circuits have been installed correctly.
7. Put the phone machine and try again dibenturkan into a hard object. If the sound does not stop means sensors stuck. Go back and give more space for the sensor relief. Simple but requires patience.